How to install in duct fans

Intake vents come in a plethora of colors, shapes, and overall styles. Know the size of the ducting before purchasing the fan as well. The fan is the main part of the system and not only will the type of fan depend on the duct sizing, but it will depend on the size of the room, the application, and other factors. Your ducting should be as straight as possible for the best results. The ductwork connects the external vent to the motor and the motor to the vent.

What Is an Inline Duct Fan? What Do These Fans Help? Several Intake Points Do you have a large bathroom? More Power Unlike standard booster fans, inline duct fans come with the option of high power motors and in large sizes. What Parts Are Needed? External Vent The external vent comes in the form of a wall vent or a mounted ceiling vent.

Fan Know the size of the ducting before purchasing the fan as well. Ducting Your ducting should be as straight as possible for the best results.

For more fans, check out our products page! Premier Source of Ventilation Equipment since Draw a line in order to indicate the place where you would install the duct fan. Make a hole at the respective place in the line and fit your inline duct fan in it. Take the steel screws and fix the duct fan in the respective place and tighten them with the screw driver. Make sure to properly attach the wires and cover them properly. Cover all the holes with the tape so that no air comes out of the duct system.

Read all the instructions carefully before turning on the unit. Also, make the thermostat is properly connected. Your email address will not be published.

If the desired location isn't right inside the segment at one end of the duct run, the duct will have to be cut open to admit the fan. When installing the fan, the installer must be sure that it is aimed so that the air blows in the desired direction.

Even though an inline duct fan may be marketed as either an "exhaust" or "intake" fan, they can all actually be installed either way. Therefore, it is important to pay attention to which way it is being put in.

Be sure that the duct fan is well-supported. This may require the construction of a support or framework, because the fan will be replacing a section of duct instead of using the duct to hold it up.

Attach the fan to the duct on each end. This will typically require bolting it on, though with flexible duct systems, you'll likely need to construct a support and then use duct tape to attach each side to the ductwork. Next, electrical connections need to be made. This gives the fan its power.